Contents
- Preface
1Sampling and Data
- Introduction
- 1.1Definitions of Statistics, Probability, and Key Terms
- 1.2Data, Sampling, and Variation in Data and Sampling
- 1.3Frequency, Frequency Tables, and Levels of Measurement
- 1.4Experimental Design and Ethics
- 1.5Data Collection Experiment
- 1.6Sampling Experiment
- Key Terms
- Chapter Review
- Practice
- Homework
- Bringing It Together: Homework
- References
- Solutions
10Hypothesis Testing with Two Samples
- AAppendix A Review Exercises (Ch 3–13)
- BAppendix B Practice Tests (1–4) and Final Exams
- CData Sets
- DGroup and Partner Projects
- ESolution Sheets
- FMathematical Phrases, Symbols, and Formulas
- GNotes for the TI-83, 83+, 84, 84+ Calculators
- HTables
- Index
9.3
Distribution Needed for Hypothesis Testing
Earlier in the course, we discussed sampling distributions. Particular distributions are associated with hypothesis testing. Perform tests of a population mean using a normal distribution or a Student's t-distribution. (Remember, use a Student's t-distribution when the population standard deviation is unknown and the distribution of the sample mean is approximately normal.) We perform tests of a population proportion using a normal distribution (usually n is large).
Assumptions
When you perform a hypothesis test of a single population mean μ using a Student's t-distribution (often called a t-test), there are fundamental assumptions that need to be met in order for the test to work properly. Your data should be a simple random sample that comes from a population that is approximately normally distributed. You use the sample standard deviation to approximate the population standard deviation. Note that if the sample size is sufficiently large, a t-test will work even if the population is not approximately normally distributed.
When you perform a hypothesis test of a single population mean μ using a normal distribution (often called a z-test), you take a simple random sample from the population. The population you are testing is normally distributed or your sample size is sufficiently large. You know the value of the population standard deviation which, in reality, is rarely known.
When you perform a hypothesis test of a single population proportion p, you take a simple random sample from the population. You must meet the conditions for a binomial distribution, which are the following: there are a certain number n of independent trials, the outcomes of any trial are success or failure, and each trial has the same probability of a success p. The shape of the binomial distribution needs to be similar to the shape of the normal distribution. To ensure this, the quantities np and nq must both be greater than five (np > 5 and nq > 5). Then the binomial distribution of a sample (estimated) proportion can be approximated by the normal distribution with μ = p and . Remember that q = 1 – p.